Comparative studies on 99mTc-pyrophosphate and 85Sr-chloride for skeletal imaging

In order to know the potential merits of 99mTc-pyrophosphate (99mTc-PYP) skeletal imaging, a comparative study was carried out by administering to the rabbit 85Sr-chloride (85Sr), classical bone-seeking agent, and 99mTc-PY simultaneously. Radioisotopic distribution was investigated as regards their deposition in the pelvic bones, and sharpness of the skeletal scintigrams, too. Both agents were remarkably affinitive to the skeletal system and there were remarkably differences in their temporal deposition pattern. Marked deposition was observed of either agent in the metaphyses. With 99mTc-PYP, the vertebral and costal systems were delineated symmetrically and each vertebral body was distinctly depicted as such 99mTc-PYP many possess the following merits over 85Sr; (1) owing to its physical properties, sufficiently large radioactivity of 99mTc-can be administered; (2) body burden of radiation absorption is reduced; (3) skeletal scintigrams of high quality are obtainable in a short period of time.     

Electrodeposition of manganese and molybdenum mixed oxide thin films and their charge storage properties

Manganese and molybdenum mixed oxides in a thin film form were deposited anodically on a platinum substrate by cycling the electrode potential between 0 and +1.0 V vs Ag/AgCl in aqueous manganese(II) solutions containing molybdate anion (MoO(4)2-). A possible mechanism for the film formation is as follows. First, electrooxidation of Mn2+ ions with H2O yields Mn oxide and protons. Then, the protons being accumulated near the electrode surface react with MoO(4)2- to form polyoxomolybdate through a dehydrated condensation reaction (by protonation and dehydration). The condensed product coprecipitates with the Mn oxide. Cyclic voltammetry of the Mn/Mo oxide film-coated electrode in aqueous 0.5 M Na2SO4 solution exhibited a pseudocapacitive behavior with higher capacitance and better rate capability than that of the pure Mn oxide prepared similarly, most likely as a result of an increase in electrical conductivity of the film. Electrochemical quartz crystal microbalance and X-ray photoelectron spectroscopy clearly demonstrated that the observed pseudocapacitive behavior results from reversible extraction/insertion of hydrated protons to balance the charge upon oxidation/reduction of Mn3+/Mn4+ in the film.     

A novel boron-rich quaternary scandium borocarbosilicide Sc3.67−xB41.4−y−zC0.67+zSi0.33−w

A novel quaternary scandium borocarbosilicide Sc_3.67−xB_41.4−y−zC_0.67+zSi_0.33−w was found. Single crystallites were obtained as an intergrowth phase in the float-zoned single crystal of Sc_0.83−xB_10.0−yC_0.17+ySi_0.083−z that has a face-centered cubic crystal structure. Single crystal structure analysis revealed that the compound has a hexagonal structure with lattice constants a = b = 1.43055(8) nm and c = 2.37477(13) nm and space group (No. 187). The crystal composition calculated from the structure analysis for the crystal with x = 0.52, y = 1.42, z = 1.17, and w = 0.02 was ScB_12.3C_0.58Si_0.10 and that agreed rather well with the composition of ScB_11.5C_0.61Si_0.04 measured by EPMA. In the crystal structure that is a new structure type of boron-rich borides, there are 79 structurally independent atomic sites, 69 boron and/or carbon sites, two silicon sites and eight scandium sites. Boron and carbon form seven structurally independent B₁₂ icosahedra, one B₉ polyhedron, one B₁₀ polyhedron, one irregularly shaped B₁₆ polyhedron in which only 10.7 boron atoms are available because of partial occupancies and 10 bridging sites. All polyhedron units and bridging site atoms interconnect each other forming a three-dimensional boron framework structure. Sc atoms reside in the open spaces in the boron framework structure.     

Oligothiophene-containing coumarin dyes for efficient dye-sensitized solar cells

We have developed oligothiophene-containing coumarin dyes fully functionalized for dye-sensitized nanocrystalline TiO(2) solar cells (DSSCs). DSSCs based on the dyes gave good performance in terms of incident photon-to-current conversion efficiency (IPCE) in the range of 400-800 nm. A solar energy-to-electricity conversion efficiency (eta) of 7.4% was obtained with a DSSC based on 2-cyano-3-[5'-(1,1,6,6-tetramethyl-10-oxo-2,3,5,6-tetrahydro-1H,4H,10H-11-oxa-3a-aza-benzo[de]anthracen-9-yl)-[2,2']bithiophenyl-5-yl]acrylic acid (NKX-2677) under simulated AM 1.5G irradiation (100 mW cm(-2)) with a mask: short-circuit current density (J(sc)) = 13.5 mA cm(-2); open-circuit voltage (V(oc)) = 0.71 V; fill factor (FF) = 0.77. Transient absorption spectroscopy measurements indicated that electron injection from NKX-2677 to the conduction band of TiO(2) is very rapid (<100 fs), which is much faster than the emission lifetime of the dye (1.0 ns), giving a highly efficient electron injection yield of near unity.     

Pre-irradiation induced grafting of styrene into crosslinked and non-crosslinked polytetrafluoroethylene films for polymer electrolyte fuel cell applications. II: Characterization of the styrene grafted films

Crosslinked and non-crosslinked polytetrafluoroethylene films (RX-PTFE and V-PTFE films, respectively) were irradiated by γ-ray and then grafted with styrene in liquid phase. Microscope FT-IR spectroscopy, TGA, solid state ¹³C CP/MAS and high resolution HS/MAS NMR spectroscopy, wide-angle X-ray diffraction (WAXD) study were used to get the structural information of the styrene grafted RX-PTFE and V-PTFE films. From microscope FT-IR spectra of the grafted RX-PTFE films, the “grafting front mechanism” was proved. TGA analysis showed that the grafted films have a small degradation step and two main degradation steps. In the ¹³C CP/MAS NMR spectra of the non-grafted films, there are no signal due to the absence of the hydrogen atom. While in the spectra of the grafted films, there are signals attributed to the polystyrene grafts. In the ¹³C HS/MAS NMR spectra of the grafted films, the relative intensity of the peaks attributed to the polystyrene grafts increased while the relative intensity of the peak attributed to PTFE matrix decreased with the increase in the DOG. From WAXD patterns, the intensity of the crystalline peak decrease with the increase in the DOG. The grafted films were sulfonated by chlorosulfonic acid and the results of highest IEC value exceeded 3.0. Those results will be reported in the near future.     

Studies on pyrazines. 29 . High regioselective synthesis of chloropyrazines from 3-substituted pyrazine 1-oxides

Reaction of 3-methoxy- or 3-chloropyrazine 1-oxides with refluxing phosphoryl chloride in the presence of amine led to a high regioselective formation of 3-substituted 2-chloropyrazines. In contrast, the use of chloroacetyl chloride instead of phosphoryl chloride enabled different regioselectivity to yield 6-substituted 2-chloropyrazines, particularly 3-methoxycarbonylpyrazine 1-oxide was almost exclusively converted into methyl 6-chloropyrazinecarboxylate under the conditions without the amine.     

First example of chiral N-heterocyclic carbenes as catalysts for kinetic resolution

Chiral N-heterocyclic carbenes, which are derived from C2-symmetric 1,3-bis(1-arylethyl)imidazolium salts, catalyze enantioselective acylation of racemic secondary alcohols.     

Effect of compression on interaction between 1,4-dihydropyridine compounds and lactose monohydrate

Manidipine dihydrochloride or benidipine hydrochloride will change to hydrate form in part, when differential scanning calorimetric (DSC) measurement is carried out together with lactose monohydrate. This interaction was accelerated by compressing their mixture. It can be suggested that the interaction may cause by the disruption of crystal structure of lactose monohydrate due to compression to set free of water molecules. A new DSC peak at 170 degrees C, which was not observed in each component, appeared in DSC measurement of a mixture. This will be based on hydrate formed by the interaction, i.e., movement of water molecules. The profile of the plotting of the DSC peak area ratio before and after compression against the compression force changed by the molar ratio of lactose monohydrate in a mixture. In the case of low molar ratio of lactose monohydrate, profiles for manidipine dihydrochloride and benidipine hydrochloride differed from each other. This will be because manidipine dihydrochloride is stickier than benidipine hydrochloride. The profile for manidipine dihydrochloride became more gradual and showed lag compression force region when the amount of addition of the lubricant, magnesium stearate in a mixture increased. The endothermic peak area at 170 degrees C for manidipine dihydrochloride was larger than that for benidipine hydrochloride. It should be suggested that benidipine hydrochloride is easier to be transformed to its hydrate than manidipine dihydrochloride.     

Photoelectron spectra and angular distribution in reson three-photon ionization of atomic iron: J dependence

Kenetic energies and angular distributions of photoelectrons emitted by three-photon ionization fo atomic iron through two-photon resonant state e⁷D_J and e⁵ D_J, were measured, by using visible lasers. J-resolved photoelectron bands attributab to the a⁶D_J and a⁴F_j ionic states are reported.